Troubleshooting Whirlpool Washer Control Board: How To Reset It And Get Your Washer Back On Track

If your Whirlpool washer is experiencing erratic behavior, such as refusing to start, not draining properly, or displaying error codes, it may be time to reset the control board. Resetting the control board can resolve various issues and restore your washer’s functionality. This comprehensive guide will provide you with step-by-step instructions on how to reset your Whirlpool washer control board, ensuring a smooth and efficient reset process.

Safety Precautions

Before attempting any repairs, it is crucial to take safety precautions:

• Unplug the washer from the power outlet.
• Turn off the water supply to the washer.
• Allow the washer to cool down completely if it has been recently running.

Step 1: Locate the Control Board

The control board is typically located on the back or bottom of the washer. It is a rectangular or square-shaped component with wires and connectors attached.

Step 2: Disconnect the Power Supply

Once you have located the control board, disconnect the power supply by unplugging the main wiring harness. This harness is usually held in place by a plastic clip or screws.

Step 3: Remove the Control Board

Depending on the model of your Whirlpool washer, you may need to remove the control board from its housing. This can be done by unscrewing the mounting screws and carefully lifting the board out.

Step 4: Wait 5 Minutes

After disconnecting the power supply and removing the control board, wait for approximately 5 minutes. This allows the residual power to dissipate from the board.

Step 5: Reconnect the Control Board

Once the 5 minutes have passed, carefully reconnect the control board to its housing, if necessary, and plug the main wiring harness back into place.

Step 6: Restore Power Supply

Reconnect the washer to the power outlet and turn on the water supply.

Step 7: Test the Washer

Run a test cycle to ensure that the reset was successful. If the washer operates normally, the reset was successful.

Additional Tips

• If the reset does not resolve the issue, there may be a more serious problem with the control board or other components. In such cases, it is recommended to contact a qualified appliance repair technician.
• Keep a record of the reset procedure for future reference or troubleshooting purposes.
• If you are uncomfortable performing the reset yourself, do not hesitate to seek professional assistance.

Troubleshooting Common Issues

• Washer does not start after reset: Check the power supply, door switch, and lid switch for proper operation.
• Washer displays error code after reset: Refer to the user manual for the specific error code and follow the troubleshooting instructions.
• Washer still not functioning properly after reset: Contact a qualified appliance repair technician for further diagnosis and repair.

Recommendations: Restoring Your Washer’s Functionality

Resetting the control board of your Whirlpool washer can be an effective solution to address various issues and restore its functionality. By following the step-by-step instructions outlined in this guide, you can safely and effectively reset your washer’s control board. Remember to take safety precautions, wait for the residual power to dissipate, and test the washer after the reset. If the issue persists, do not hesitate to seek professional assistance. With proper care and maintenance, your Whirlpool washer will continue to provide reliable performance for years to come.

Questions You May Have

Q: How often should I reset my Whirlpool washer control board?
A: Resetting the control board is not a regular maintenance procedure. It is only necessary when the washer is experiencing specific issues.

Q: Can I use a different control board from another Whirlpool washer model?
A: No, it is not recommended to use a control board from a different model. Each model is designed with specific compatibility requirements.

Q: What are the signs that the control board needs to be reset?
A: Common signs include: washer not starting, not draining properly, displaying error codes, or erratic behavior.