Attention Maytag Epic Z Owners: Step-By-Step Reset Instructions Revealed
What To Know
- If the washer is connected to a circuit breaker, reset the breaker by turning it off and then back on.
- Remember that resetting the washer should be a temporary solution, and if the problem persists, it’s essential to seek professional assistance to prevent further damage.
- After the reset, the washer should start a diagnostic cycle or display a “Reset Complete” message.
If your Maytag Epic Z washer is malfunctioning, resetting it may resolve the issue. This guide provides a step-by-step process on how to reset your washer, ensuring it operates smoothly again.
Why Reset Your Maytag Epic Z Washer?
Resetting your washer can address various problems, including:
- Error codes or flashing lights
- Failure to start or complete cycles
- Water leaks or drainage issues
- Unusual noises or vibrations
Before You Reset
Before proceeding with the reset, ensure the following:
- Unplug the washer from the power outlet.
- Turn off the water supply to the washer.
- Clear any debris or blockages from the drain hose or filter.
Step-by-Step Reset Instructions
Method 1: Power Cycle
1. Unplug the washer and wait 1 minute.
2. Plug the washer back in and wait 5 seconds.
3. Turn on the water supply.
4. Select a wash cycle and start the washer.
Method 2: Control Panel Reset
1. Unplug the washer.
2. Press and hold the “Cycle Select” and “Soil Level” buttons simultaneously for 10 seconds.
3. Release the buttons.
4. Plug the washer back in.
5. Turn on the water supply.
6. Select a wash cycle and start the washer.
Method 3: Factory Reset
1. Unplug the washer.
2. Press and hold the “Power” and “Start/Pause” buttons simultaneously for 5 seconds.
3. Release the buttons.
4. Plug the washer back in.
5. Turn on the water supply.
6. The washer will automatically enter factory reset mode.
Additional Troubleshooting Tips
If resetting the washer does not resolve the issue, consider the following:
- Check the power cord and outlet for damage.
- Inspect the water inlet hoses for leaks or kinks.
- Clean the drain pump filter located at the bottom of the washer.
- Contact a qualified appliance repair technician for professional assistance.
Other Ways to Reset Your Washer
Unplug and Replug: Unplug the washer and wait 1 minute before plugging it back in. This simple action can sometimes reset the washer.
Circuit Breaker Reset: If the washer is connected to a circuit breaker, reset the breaker by turning it off and then back on.
Wrapping Up: Troubleshooting Reset Issues
If you encounter any difficulties while resetting your Maytag Epic Z washer, refer to the user manual or contact Maytag customer support. Remember that resetting the washer should be a temporary solution, and if the problem persists, it’s essential to seek professional assistance to prevent further damage.
Popular Questions
Q: How often should I reset my Maytag Epic Z washer?
A: Resetting the washer should only be done when necessary to address specific issues.
Q: Can I reset my washer if it’s not plugged in?
A: No, the washer must be plugged in for the reset to be effective.
Q: Why does my washer keep resetting itself?
A: Frequent resets may indicate an underlying issue that requires professional attention.
Q: What happens if I reset my washer to factory settings?
A: Factory reset will erase all customized settings and restore the washer to its original default settings.
Q: How do I know if my washer has been successfully reset?
A: After the reset, the washer should start a diagnostic cycle or display a “Reset Complete” message.