How To Replace A Maytag Washer Timer Knob In 6 Easy Steps (Ultimate Guide)

If your Maytag washer‘s timer knob is giving you trouble, don’t despair. Replacing it is a relatively simple task that you can do yourself with just a few basic tools. Here’s a step-by-step guide to walk you through the process:

Gather Your Tools

Before you start, make sure you have the following tools:

• Phillips head screwdriver
• Flathead screwdriver
• Needle-nose pliers
• New timer knob

Safety First: Unplug the Washer

Before you begin any work on your washer, always unplug it from the power outlet to prevent electrical shock.

Remove the Old Timer Knob

1. Locate the set screw: On the back of the timer knob, you’ll find a small set screw.
2. Loosen the set screw: Use a Phillips head screwdriver to loosen the set screw, but don’t remove it completely.
3. Pull off the knob: Gently pull the timer knob straight off the stem.

Disconnect the Wires

1. Identify the wires: Inside the timer knob cavity, you’ll see two wires connected to terminals.
2. Disconnect the wires: Use a flathead screwdriver to gently pry the wires off the terminals.

Remove the Old Timer

1. Locate the retaining nut: On the back of the timer, you’ll find a retaining nut.
2. Loosen the nut: Use a needle-nose pliers to loosen the nut, but don’t remove it completely.
3. Pull out the timer: Gently pull the timer straight out of the washer.

Install the New Timer

1. Insert the new timer: Align the new timer with the hole in the washer and push it into place.
2. Tighten the retaining nut: Use the needle-nose pliers to tighten the retaining nut securely.

Connect the Wires

1. Strip the wire ends: Use a wire stripper to remove about 1/2 inch of insulation from the ends of the two wires.
2. Connect the wires: Push the stripped wire ends onto the terminals on the new timer.
3. Secure the wires: Use needle-nose pliers to gently crimp the wire ends onto the terminals.

Install the New Timer Knob

1. Align the knob: Align the new timer knob with the stem on the timer.
2. Press on the knob: Push the knob onto the stem until it clicks into place.
3. Tighten the set screw: Use a Phillips head screwdriver to tighten the set screw on the back of the knob.

Test the Washer

1. Plug in the washer: Reconnect the washer to the power outlet.
2. Run a test cycle: Select a short wash cycle and start the washer to test the new timer knob.

Wrap-Up: A Job Well Done!

Congratulations! You’ve successfully replaced your Maytag washer timer knob. With this simple repair, you’ve saved yourself the cost of a service call and ensured that your washer is back up and running smoothly.

Top Questions Asked

Q: My timer knob is loose and won’t stay in place.
A: Tighten the set screw on the back of the knob more securely. If it’s still loose, you may need to replace the knob.

Q: The timer doesn‘t advance after I turn the knob.
A: Check the wires to make sure they are securely connected to the terminals on the timer. You may also need to replace the timer.

Q: The washer doesn‘t start when I turn the timer knob.
A: Check the power connection and make sure the washer is getting power. You may also need to replace the timer or the start switch.