How To Replace Indesit Washing Machine Drum Paddle: A Step-By-Step Guide For Diy Repairs
What To Know
- Replacing the drum paddle in an Indesit washing machine is a relatively simple task that can be completed in under an hour.
- Align the holes in the paddle with the holes in the drum.
- Replacing the drum paddle in an Indesit washing machine is a simple task that can be completed in under an hour.
Replacing the drum paddle in an Indesit washing machine is a relatively simple task that can be completed in under an hour. With the right tools and a little bit of patience, you can save yourself the cost of calling a repairman.
Tools and Materials You’ll Need
- Phillips head screwdriver
- Flat head screwdriver
- New drum paddle
- Bucket
- Rags
Step-by-Step Instructions
1. Unplug the Washing Machine
Before you begin, unplug the washing machine from the power outlet. This will prevent any electrical accidents.
2. Remove the Back Panel
Locate the screws that hold the back panel in place and remove them using a Phillips head screwdriver. Carefully lift the back panel off the machine.
3. Locate the Drum Paddle
The drum paddle is located at the back of the drum. It is a plastic or metal piece with several paddles that help agitate the clothes during the wash cycle.
4. Disconnect the Wires
Disconnect the wires that are connected to the drum paddle. Use a flat head screwdriver to gently pry the connectors apart.
5. Remove the Drum Paddle
Use a Phillips head screwdriver to remove the screws that hold the drum paddle in place. Carefully lift the drum paddle out of the machine.
6. Clean the Area
Use a rag to clean the area where the drum paddle was located. Remove any dirt or debris that may have accumulated.
7. Install the New Drum Paddle
Place the new drum paddle into the machine. Align the holes in the paddle with the holes in the drum.
8. Tighten the Screws
Tighten the screws that hold the drum paddle in place using a Phillips head screwdriver.
9. Reconnect the Wires
Reconnect the wires that you disconnected earlier. Push the connectors together until they snap into place.
10. Replace the Back Panel
Carefully lift the back panel onto the machine. Align the holes in the panel with the holes in the machine.
11. Tighten the Screws
Tighten the screws that hold the back panel in place using a Phillips head screwdriver.
Troubleshooting
If you encounter any problems while replacing the drum paddle, here are a few tips:
- If you cannot remove the back panel, try using a putty knife to gently pry it off.
- If you cannot disconnect the wires, try using a pair of needle-nose pliers to gently pull the connectors apart.
- If you cannot tighten the screws, try using a drill with a screwdriver bit.
The Bottom Line
Replacing the drum paddle in an Indesit washing machine is a simple task that can be completed in under an hour. By following these instructions, you can save yourself the cost of calling a repairman.
What People Want to Know
How much does it cost to replace a drum paddle?
The cost of a drum paddle varies depending on the make and model of your washing machine. However, you can expect to pay between $20 and $50 for a new paddle.
How long does it take to replace a drum paddle?
Replacing a drum paddle typically takes between 30 and 60 minutes. However, the time may vary depending on your skill level and the make and model of your washing machine.
What are the signs of a faulty drum paddle?
There are several signs that may indicate a faulty drum paddle, including:
- The washing machine is not agitating the clothes properly.
- The washing machine is making a loud noise during the wash cycle.
- The washing machine is leaking water from the back.