Miracle Cure: The Ultimate Guide To Draining Whirlpool Dishwasher Standing Water

If you’re facing the inconvenience of standing water in your Whirlpool dishwasher, don’t despair. Draining the water and resolving the issue is achievable with the right steps. This guide will provide you with a comprehensive approach to effectively drain your Whirlpool dishwasher and identify potential causes.

Safety Precautions

Before proceeding, ensure you take the necessary safety precautions:

• Unplug the dishwasher from the power outlet.
• Turn off the water supply to the dishwasher.
• Wear gloves to protect your hands from any sharp objects or chemicals.

Step-by-Step Instructions

1. Remove Standing Water Manually

• Open the dishwasher door and use a cup or bowl to scoop out as much water as possible.
• Tilt the dishwasher slightly to allow the remaining water to drain.

2. Locate the Drain Filter

• Open the bottom panel of the dishwasher.
• Locate the drain filter, typically situated at the bottom of the dishwasher’s interior.
• Remove the drain filter by unscrewing or pulling it out, depending on the model.

3. Clean the Drain Filter

• Rinse the drain filter under running water to remove any food residue or debris.
• Inspect the filter for any damage or blockages.
• Reinstall the clean drain filter securely.

4. Reset the Dishwasher

• Once the drain filter is cleaned, press the “Reset” button on the dishwasher’s control panel.
• If there is no “Reset” button, unplug the dishwasher for a few minutes and then plug it back in.

5. Start a Rinse Cycle

• Start a rinse-only cycle without any dishes or detergent.
• This cycle will help flush out any remaining water or debris from the dishwasher.

6. Check for Leaks

• After the rinse cycle, inspect the dishwasher for any leaks.
• If you notice any leaks, contact a qualified appliance repair technician.

Potential Causes of Standing Water

• Clogged Drain Filter: Food residue or debris can accumulate in the drain filter, blocking the water from draining.
• Faulty Drain Pump: The drain pump is responsible for pumping the water out of the dishwasher. If it fails, water will not drain properly.
• Blocked Drain Hose: The drain hose can become kinked or clogged, preventing the water from flowing out.
• Malfunctioning Float Switch: The float switch detects the water level in the dishwasher. If it fails, the dishwasher may not drain properly.

Key Points: Resolving Standing Water in Your Whirlpool Dishwasher

By following these steps and addressing potential causes, you can effectively drain the standing water in your Whirlpool dishwasher. Remember to take the necessary safety precautions and consult a qualified appliance repair technician if you encounter any difficulties or leaks.

Information You Need to Know

Q: Why is there standing water in my Whirlpool dishwasher?

A: Standing water can be caused by a clogged drain filter, faulty drain pump, blocked drain hose, or malfunctioning float switch.

Q: How often should I clean the drain filter in my Whirlpool dishwasher?

A: It is recommended to clean the drain filter every 1-2 months to prevent blockages and ensure proper drainage.

Q: What should I do if I notice leaks in my Whirlpool dishwasher?

A: If you notice any leaks, unplug the dishwasher and contact a qualified appliance repair technician immediately to prevent further damage.